CAN/CSA E335-2-40-94

1. Scope This clause of part 1 is applicable except as follows: 1.1 Replacement: This part of IEC 335 applies to the safety of electric heat pumps, including heat pumps for sanitary (potable) hot water, air-conditioners, and dehumidifiers incorporating sealed motor- compressors. The appliances referenced above may consist of one or more factory made assemblies. If provided in more than one assembly, the separate assemblies are to be used together, and the requirements are based on the use of matched assemblies. A definition of ''sealed motor-compressor'' is given in IEC 335-2-34. Requirements for refrigeration safety are covered by ISO R1662, and requirements for containers intended for storage of the heated water included in sanitary hot water heat pumps are, in addition, covered by IEC 335-2-21. Supplementary electric heaters, or a provision for their separate installation, are within the scope of this standard, but only heaters which are designed as a part of the appliance package, the controls being incorporated in the appliance. This standard does not apply to - appliances designed exclusively for industrial processing; - appliances intended to be used in locations where special conditions prevail, such as the presence of a corrosive or explosive atmosphere (dust, vapour or gas). For appliances intended for use in vehicles or on board ships or aircraft, additional requirements may be necessary. Attention is drawn to the fact that in many countries additional requirements are specified by the national health authorities, the national authorities responsible for the protection of labour and the national authorities responsible for building design and regulation. In the case of appliances for permanent connection to the water supply system, all relevant requirements shall be observed. / 1. Domaine d'application L'article de la premiere partie est applicable avec l'exception suivante: 1.1 Remplacement