AWS A5.7/A5.7M:R2017

This specification prescribes the requirements for classifications of copper and copper-alloy electrodes and rods for gas shielded metal arc, gas shielded tungsten arc, and plasma arc welding. Classification is based on chemical composition of the filler metal. Additional requirements are included for manufacture, sizes, lengths, and packaging. A guide is appended to the specification as a source of information concerning the classification system employed and intended use of the electrodes. This specification makes use of both U.S. Customary Units and the International System of Units (SI). Since these are not equivalent, each system must be used independently of the other.
Scope : 1.1 This specification prescribes requirements for the classification of copper and copper-alloy bare welding rods and electrodes for plasma arc, gas metal arc, and gas tungsten arc welding. It includes compositions in which the copper content exceeds that of any other element.1 1.2 Safety and health issues and concerns are beyond the scope of this standard and, therefore, are not fully addressed herein. Some safety and health information can be found in the informative annex clauses A5 and A10. Safety and health information is available from other sources, including, but not limited to, ANSI Z49.1, Safety in Welding, Cutting, and Allied Processes, and applicable federal and state regulations. 1.3 This specification makes use of both U.S. Customary Units and the International System of Units (SI). The measurements are not exact equivalents; therefore, each system must be used independently of the other without combining in any way when referring to material properties. The specification with the designation A5.7 uses U.S. Customary Units. The specification A5.7M uses SI Units. The latter are shown within brackets [ ] or in appropriate columns in tables and figures. Standard dimensions based on either system may be used for sizing of filler metal or packaging or both under A5.7 or A5.7M specification